Defender SN500-4CH Instruction Manual download pdf (Page 11)

SN502-4CH

BASIC SETUP

Things to Consider Before Installation

• The camera should be installed between 8 and 13ft above the area to be monitored

• Before screwing in the mount for the camera ensure there are no obstructions in the camera’s view

• Place cameras in the most strategic places where they can provide detailed, recorded video of every visitor.

• Having the camera in the open for people to see can help deter criminals

• To cover large, dark areas such as backyards, garages, and driveways, place cameras in strategic locations, such as on

the roof or deck, this way, less cameras are needed to cover an area

• Ensure that the sunshade is positioned to avoid glare and be sure to position camera away from direct sunlight or

other light sources

• For best results, the light in front of the camera should be about the same brightness as the light around the area or

object being monitored

• Decide whether the camera will be wall-mounted, ceiling mounted or sit on a desk/table top. If you are mounting

the camera on a wall or ceiling, use the included mounting hardware. We recommend that the mounting bracket is

secured using the included screws for all installations

• Each camera comes with 60ft of video/power wire please make sure that you mount the cameras no more than

60ft from the DVR. If longer wiring distance is required, 60ft extensions can be purchased (DF10W) from your local

re-seller or at www.defender-usa.com

• We recommend using a surge protected power bar to protect the camera’s internal circuitry

Mounting the Cameras

1. Decide if the camera will be wall-mounted or sit on a

desk/tabletop. The camera can be adjusted for either

mounting scenario by rotating it to the required

position.

2. Screw the mounting bracket into the camera’s

mounting hole, turning it clockwise.

3. Mount the camera in the desired location no more

than 60 ft from the DVR unless you have purchased

additional wiring. You may mount the cameras on a

wall, ceiling or desk.

4. Ensure that the cameras are strongly secured into

the wall.

5. Adjust cameras to the desired viewing angles.

6. For additional help on mounting the cameras, please

see the drilling template, located at the back of the

manual.

Adjust camera to desired viewing angle

Ensure the camera is secured into place

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 89 90

No comments

Defender SN500-4CH Instruction Manual Page 11