Defender DVR Instruction Manual download pdf (Page 16)

SN501-16CH

Note: We recommend using a surge protected power bar and/or Uninterrupted Power Supply (UPS) backup to prevent damage to

your DVR system.

1. Insert the power cord into the

power supply.

2. Plug the power cord into a power outlet. 3. Insert the power supply wire into the

rear DC 12V port on the DVR.

4. The DVR will turn on and display the main viewing area after a few moments of initializing.

CONNECTING YOUR DVR TO THE ROUTER

1. Power o the DVR by removing the power cable from the back of the DVR.

2. Connect the included network cable to the back of the DVR in the “Ethernet”

port (LAN).

3. Connect the other end of the network cable to an available port on the

router. The ports should be labeled 1-4, or 1-8.

4. Power on the DVR by reconnecting the power cable on the back of the DVR.

Note: If you look at the router there should be a green “link” light

indicating that the DVR is properly connected to the port that it

was plugged into. There will also be an amber and green “link”

light to the right of the Ethernet connection on the back of the

DVR to indicate a proper connection to the router. If both “link”

lights are illuminated, the DVR is properly connected to the router

and you can proceed with the next step.

CONNECTING DEVICES

POWERING ON THE DVR

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 77 78

No comments

Defender DVR Instruction Manual Page 16